Posts

Chosen Solution Went through some of the questions previously asked for the same problem/device. I’ve replaced several parts over the years on my iPhones without trouble, but recently when I tried to do a screen replacement, when I turn the phone on, I can see that the LCD lights up, but I only get a black screen. I can also tell that the TouchID is working, as my phone buzzes to let me know that I need to input my passcode upon rebooting the phone....

Chosen Solution Hello everybody, i repaired on iphone 7 audio ic fault, BB pmu error and not working wifi by placing wires under IC’s. After all my work everything works fine but when i try to twist housing or put some pressure on it, phone start boot loop. Where could i look next? Can be fault under BB CUP or somewhere i do not know by flexing board? Thanks for help....

Chosen Solution HELP my iphone is now in a endless bootloop. I can’t turn off iphone also can’t get it into recovery. How can i get the phone off? Eventually the phone will turn off when the battery is depleted…but that’s probably not what you want to hear ;>). You don’t really explain what happened to your phone before this issue. Was it dropped or did it come in contact with water?...

Chosen Solution The brake pedal is soft on my 2002 ford f150. Changed master cylinder, didn’t change condition. Start with the fluid level in the master cylinder and work your way out from there checking lines at abs and working back to all four corners of the truck. Check the rear brake cylinders pull the rubbers bake and check for fluid if there leaking you’ve found you problem. otherwise look for leaking fluid somewhere else

Chosen Solution Hello, Galaxy Tab S 10.5 Initial problem - “kernel is not seandroid enforcing” on boot attempt I used Odin3 to put original tar.md5 image which I downloaded with Frija. Odin3 did not report any errors. Boot pattern changed but still did not boot. I tried to use Odin3 again but it was only giving “RQT_CLOSE “ error on upload attempt. I did “wipe data/factory reset” and “wipe cache”. It showed multiple red lines in output with “failed to mount cache” being one of them....

Chosen Solution The question is ! Do you have to buy the lcd and screen together ?? I broke my iPod 4G screen and have been surfing the web for 2 weeks now and watching videos on YouTube for repairing the unit and have found videos doing both, outter screen and also “under, inner” LCD for the iPod 4g just replacing the outer screen, just replacing the lcd, and replacing “both” the under lcd and outer screen ?...

Chosen Solution Hypothetically, Assumed my iMac’s GPU burned, and I need to replace it. What GPU would you choose, and why? I mean there are lot of stories that I can put better GPU and enjoy the games and so on, but what about Power Supply, will it be enough watts to feed stronger GPU? And do I need run my fans faster to keep it from burn? And opposite side, if I just need to got cheapest GPU which will allow me to work on this machine (no games), what will be the best choice?...

Chosen Solution Hi! Got a fairly unused desktop lamp from my father which, according to him, only needed a new AC-adapter. Went and got a new one this morning but when i plugged it in it still didn’t work. Noticed som odd stains on top of the lamp, looked like it came from toothpaste, which had run down and in where the on and off switch is located. Decided to open it up to see if that was the reason for the problem....

Chosen Solution Can a 13” 2013 ssd fix into a 11 inch 2012 model MacBook Air? Simple answer is no, they have different shapes and sizes. 2012 Flash drives are not compatible with any earlier or later ones. Its a bit more complicated than physical fit the dialog of the drive needs to be compatible. Review this guide The Ultimate Guide to Apple’s Proprietary SSDs

Chosen Solution So I tried to change the iPad screen. I was pulling out the lcd cable and the old screen cable at their connection points, but I didn’t realized they slid out. I started peeling away all the the tiny small pins away and i think i ruined it. Can this be fixed? It can be fixed but not easily and takes time. I’m guessing some pads that hold the soldered pins for the ZIF connectors have gone missing after being ripped off....

Chosen Solution Hello guys! I am now using a 8g ddr3 1600 ram(1.5v) now and mac mini is working fine. Can I install another 8g ddr3l (low voltage, 1.35v) at the same time? Because normal voltage(1.5v) ram is very rare now. Yes, DDR3L is compatible with DDR3 based systems. However, DDR3 is not forwards with DDR3L based systems, if the system requires DDR3L then installing DDR3 may not work. Do make sure all of the other requirements match....

Chosen Solution My current A1211 logic board needs to be replaced but I want to move to 64 bit ROM in order to install the current release of OSX. Can I install an A1226, which appears to match in all significant respects except for the processor and video card. It would be a very large undertaking and I’m not sure it would buy you that much if it worked. Remember this series has a known issue with the GPU so you can’t push it that hard without it failing....

Chosen Solution I have a iphone 5 with some camera clarity issues i have a dead iPhone 5s with a camera in perfect condition can i replace my iphone 5 rear camera with iPhone 5s camera Unfortunately they are different

Chosen Solution I was trying to install a tempered glass screen protector that uses UV glue to set it to the screen and my phone ended up getting like soaked in the stuff (it would just run off the edges and not evenly go under the screen protector) (i ended up just removing the screen protecter and went back to plastic) is it possible that the uv glue was able to go past any of the waterproofing barriers in the phone?...

Chosen Solution I have an S7 Edge. It has worked fine for 2+ years, and it still fits my needs. I planned on using this as long as I could. I have had zero issues with it up until today. I plugged it in to charge last night. When I woke up this morning, I cannot unlock it. I use a PIN, and the number pad does not come up. The screen appears normal–notifications, time, background image....

Chosen Solution Hi, Is it possible to take out the 256 GB SSD out of an Macbook Air 13" and put it in an 11" Macbook Air ? Both newest generation of course. Thanks! Update Thanks for your reply and link. I am just a bit worried because someone told me that the SSD Card in the 11" Air is directly stored above the ram ! ( different to the 13" Air ) I was told that the memory on the 128 SSD-Card is only on one side of the card ( while on both sides at the 256 GB SSD-Card)....

Chosen Solution Hello Sorry for my poor english level (I’m french). My macbook’s keyboard (13" Unibody white (Model A1342) Late 2010) is dead and I try to change it. I see a macbook keyboard (model A1278 macbook pro 13" unibody) cheap and I would know if we can put keyboard of macbook A1278 on a macbook A1342 ? Two kinds of keyboards seems to be the same. Thank you Cordialy...

Chosen Solution Would it be possible to retro fit a corsair h80i onto the mac mini if it were in a separate enclosure? Seth Potter, can it be done? Sure it can but will require some ingenuity on your part. Check on here for some fun reading. Sorry, not really possible. It would require a major overhaul of the case to get the modified logic board to even fit.

Chosen Solution I just bough an apple cinema monitor for a steal of a $160(No Glass), I was thinking about making my own glass in acrylic is that possible? It shouldn’t be to hard because the glass is connected to the display by magnets, so I could just glue metal on to the back. N T I cannot see any reason why that would not work. It may be not quite as aesthetic but should still be functional....

Chosen Solution My kindle has been sat on and the glass screen itself is okay but it seems that the issue is internal because I cannot see the contents of the kindle as it’s cracked. Can this be fixed? you can get a new display for around 20-50 dollars on ebay http://www.ebay.com/bhp/kindle-3-replace… This video can guild you through the process https://www.youtube.com/watch?v=Wf2z9jZV… Hope this helps