Posts

Chosen Solution I recently ordered a Keurig Elite to the Middle East and completely forgot about the voltages and plugged it into a 220V power outlet. There were no sparks or smoke coming out of the machine though. Just a loud ‘pop’ noise, and the electricity in the house completely got cut off. Is there any way my Keurig can be fixed by an electrician or technician? or did I just throw money down the drain?...

Chosen Solution If I disassemble an iPad, is it possible to replace the internal flash mass memory with a 128GB Samsung SSD 1.8"? what is kind of the iPad’s flash mass memory? does the quality of the internal multimedia decrease? Would iTunes support the modified iPad? Would I be able to install the iOS 4.2? Thanx for the answer. No. The NAND flash is soldered to the main board, and it does not have an interface that’s compatible with an SSD (or space inside for a drive)....

Chosen Solution Totally ordered the wrong battery and need to order the right one. Possible to get an RMA online? This is the volunteer DYI help forum, we are not affiliated with iFixit in anyway. Use the link at the bottom of the page to contact iFixit direct. If this answer is acceptable please remember to return and mark it.

Chosen Solution My older ipad I cant I use some games and wifi connection is slow. Can I increase the ram and processor chip or gaming chip? No, it’s all integrated into the logic board and can’t be changed. Hi Mayer I am wondering if , as a casual phone and tablet repairer with the right tools could a new faster processor and larger flash memory be swapped. I have seen this done with 16 to 128 gb memory in a galaxy s6 by Deep Fix....

Chosen Solution Hi, i broke pad no. 2 removing rest of damaged lvds. So i need to make a jumper once soldered the new connector, but I don’t know where to conect the jumper. Could somebody help me to tell me where connect. I would thank a diagram or any visual picture. thanks a lot in advance A specific board number may be helpful since there are some variations of the board from what I could tell and it may affect the location of some components....

Chosen Solution Can the internal components be adjusted to allow for Watch OS 4 features. Many people have said that the sensors used have been built in since the beginning, so what needs to be changed to get latest OS4 This Series of Apple Watches supports watchOS 4.x. It can’t run anything newer. Using your iPhone you should be able to install the last supported version without any difficulties.

Chosen Solution Apart from internet calling can we make voice calls through carrier sims in iPad Air 2? Well sorta … You can use Skype to create a VoIP callYou can use FaceTime to create a video/voice callDepending on your carrier you can make a tunneled call In all of these you are not creating an analog 3G call which is what Tom is referring to. These are LTE digital connections....

Chosen Solution I am looking at buying an early 2011 macbook pro which needs some replacements. They have uploaded a video which shows that one of the black antenna cables have broken in half. He says that you could solder this cable back together. Will it work? I could get a soldering kit, but I just need to know if it is: A) Possible? B) How difficult? C) Is it worth doing?...

Chosen Solution My Dualshock 4 stopped charging after I had used it for a couple of months (previous owner too so not sure how long it’s been in use). I did the first fix I read which was to change the Micro USB port which I have done. Now, when I plug the controller in, it turns on for a fraction of second then straight back off again with no glowing orange light to indicate it is charging whereas before it wouldn’t turn on at all, even when plugged in before I replaced the port....

Chosen Solution This S5 Came into the shop, normal thing, turning on but screen unresponsive. So ordered another Screen from my normal supplier. After receiving screen started the change over Full picture: As I’m sure we all do when changing these screens Changed Charge port Changed Screen Tested: And all that I got was a screen full of pixels (as in pic). checked connector, cables never had this with an S5 before, in fact any screen....

Chosen Solution A few months ago, my left speaker started crackling. I changed the sound balance settings to the right, and it was all good. But, a few weeks later, my right speaker also started crackling! The sound is all fine when I use a headset. I removed the speakers to check for damage, but the membranes looks in tact. I’ve tried most other software fixes I found online, but can’t seem to figure out what’s wrong....

Chosen Solution OK so I’m sure most people have it they strip down phones and get collections of old screws … Well I know the screws in a device are all different lengths 1.2 1.4 etc .. And in newer devices different heads tri instead of Philips etc. But are the size screws all the same between devices so could I have a tub of just Apple 1.3mm Philips then another 1....

Chosen Solution Hi, I have recently replaced the battery in my MacBook Pro 15" Retina Display Mid 2014 after ordering one on IFixit. This all went well and worked perfectly up until recently. 2 months later my charger stopped working and would not show any green or orange light when plugged in so I bought a second hand one to see if it was in fact the charger. (I do not believe the new battery could have broken my charger but shortly after the battery stopped holding charge as well so this might be correlated....

Chosen Solution I have an iBook g4 14", with charging problems. I have tried 3 new batteries and all do the same. When I plug my computer in to the adapter the adapter light turns yellow and charges for about 6 min. then turns green. Each time another of the little lights on the battery usually turns green. The computer runs fine off power adapter. I take out the battery and replace it right away and adapter light turns yellow and will charge for another few minutes then turns green and stops charging....

Chosen Solution Battery on Samsung Rant phone does not snap all the way & cover won’t close tight,what would cause this? JANET LANGEBERG, to get the battery completely seated, make sure that you have the right battery. If you are certain you do, check the battery contacts on the phone. Make sure they are not bend and keep the battery from being properly seated. Anything else, there is no reason for the battery not to fit properly....

Chosen Solution Hey guys, I have to say that I’m completely new to iPhone as a daily driver so maybe my values are default. But I guess they’re not, at least I can’t imagine they are. Another problem I’ve got on my “new” iPhone 5s (iOS 10.2) which I just completely reassembled. When I use it and just browse the internet via wifi I notice a battery drain of about 1 % per 1....

Chosen Solution i installed the new battery i purchased with the required tools from ifixit all went well i completed the job in about 20 minutes. the phone came on instantly bur felt very hot so i shut down the phone the normal way. but it will not restart. my iphone is the se Chances are something got shorted in the process. Try reseating all connectors, including those belonging to the screen assembly in the upper part after checking with a magnifier all pins on both sides are straight and in good shape....

Chosen Solution I have a few devices here “iPhones and iPads” that I’ve collected over time, they all have NAND related issues, error codes 4014 and also error 9. I’m looking for some recommendations on reliable company’s who have a naviplus pro or similar that can reprogram nand chips and fit them, any advice would be greatly appreciated! Many thanks Harry This forum is not for marketing professional services, it’s a forum to help DIY fixers....

Chosen Solution hello I have a MBP mid 2010 and ive tried all types of solutions to fix my Bluetooth problems ex. iphone , speakers, etc.Well my question is that if it is possible to change the BT card or any improvement so I can be able to connect my iphone and such devices also it is an LMP: 2.1 (0x4) and is not handoff supported. I recently upgraded my mac, I bought a 16 GB (8GB + 8GB) ram memory, a 480 SSD, and a new battery....

Chosen Solution Hi All, Just got a replacement macbook air board (2015 model) to replace the failed motherboard on my macbook. After installing the board, as soon as the power is connected, screen turns on, shows red low battery icon and then the fans spin up and then turns off. This goes on for 3 times and then completely turns off. If I disconnect the battery however, the computer would turn on....